AIRWAVE FOIL ACCESSORIES

FW 1325

The pre-preg carbon front wing is held in place with three screws M8 x 30.

FW 1325 – Wing span 78 cm (30.7″) and is 22 cm wide (8.66″) with a total size of 1,325 square cm (205.3 sq inch).

FW 1700

The pre-preg carbon front wing is held in place with three screws M8 x 30.

FW 1700 – Wing span 85 cm (33.4″) and is 25 cm (9.84″) with a total size of 1700 square cm (263.5 sq in).

RW 340

The pre-preg carbon rear wing is held in place with two screws.

340 M-shaped – Wing span 42 cm (16.5″) and is 10 cm wide (3.9″) with total area of 340 square cm (52.7 sq in).

RW 330

The pre-preg carbon rear wing is held in place with two screws.

330 Flat –  Wing span 39.5 cm (15″) and is 11 cm wide  (4.3″) with a total area of 330 square cm (51 sq in).

Mast 60, 70, 80, 90, 100

Anodized aluminum mast with reinforced internals for unparalleled rigidity.

Available in 5 sizes – 60 cm (23.6″), 70 cm (27.5″) and 80 cm (31.4″), 90 cm (35.4″) and 100 cm (39.3″)

Fuselage 70

The centrepiece of the foil. This anodized aluminum, hydrodynamically, CNC cut fuselage measures 70 cm (27.5″). Slots seamlessly onto the mast and holds the front wing, the back wing and the tuning shims.

RW Tuning Shims

Three rear wing anodized aluminum shims allow you to trim your foil for different water conditions. Available in 1, 2, and 3 degrees.

Four M8 x 30 bolts

Four high-grade stainless steel bolts with M8 countersunk torx head sockets will take the required torque to secure your foil to the board without stripping. Corrosion resistant nuts, sourced for marine applications, allow tuning of your setup as you slide them up or down the twin rack mount.

Airwave Mounting Plate

Mounting Plate

Designed to spread the load, the anodized aluminum base features screw slots instead of holes, allowing for additional fine tuning.

FW Screws M8 x 30

Mount your Front wing to the fuselage with three high-grade stainless steel bolts, featuring M8 countersunk torx head sockets.

Mast Screws M6 x 45

Six extended screws connect your Airwave mast to the fuselage and mounting plate, with M6 countersunk torx head sockets.

Tuttle Converter

Have a slalom surfboard laying around or a foilboard with a tuttle box? Now you can rig up your Airwave with a tuttle system too.

Contact a local distributor or retailer to order your Airwave foil accessories now.

What’s in the bag?

Apart from the accessories offered on his page, the NSP Airwave comes as a complete kit, with a setup that will have you foiling in no-time, all in one package.